Make Noise Rene firmware

1. New functionality: gate ties! A “gate tie” behavior is added to FUN.OP.TRIG. When FUN.OP.TRIG is turned on, non-Glide-enabled locations still output triggers as before. When a location is reached with Gate and Glide both enabled, the channel’s Gate output will go and stay high until a non-Glide-enabled location is reached, at which point the Gate output will go low. This allows multiple gates to be tied together for the creation of varia- blelength note events. In classical music terms, a gate tie between locations with the same note value is a “tie,” and a gate tie between locations with different note values is a “slur.” Because the length of a gate tie is determined by the number of Glide-enabled locations that the sequence passes through in a row, differing Cartesian and Snake patterns will result in differing rhythms even on the same State. Note: When FUN.OP.SLEEP is turned on and Access-disabled States are being “skipped,” gate tying will only happen if the location that is being "held" is Glide-enabled. In this case gate tying will begin when a Gateenabled location is reached or skipped, and will not end until an Access-en- abled and Glide-disabled location is reached. In other words, René acts as if all skipped locations have the same Glide setting as the held location. Gate-tying, like all Program Page operations, is per channel and per State. 2. Bug fixes NOTE: If you are using TEMPI with René via the Select Bus, then you must also install the TEMPI firmware, which is included in the firmware package. Firmware available at https://www.makenoisemusic.com/firmware