Arturia MatrixBrute firmware

New features - Sleep mode/Screen saver - Song position pointer handling Bugfixes SEQUENCER - When slaved, playback now stays in sync when loading a new preset - Sequencer is not randomly stopped when looping in certain DAWs - When slaved, sequencer no longer starts by itself when disabling MIDI Sync - In MIDI sync + Record on, no more stuck note when holding a key and pressing play on Master device - Sequence no longer drifts in time when slaved with 1&2PPQ - Hold a tied step (dim lit) and change its note (turn mod amount) doesn't transform it into a trigger step (full lit) anymore LFO - When MIDI slaved and the sequencer playing, LFOs phase could be offset after loading a new sequence preset - LFO Phase could be offset when restarting the Sequencer with Restart button when SeqMod<0 - LFO 2 Rate modulation was applied on 2nd key press when modulated by Kbd/Seq Duo Split - Lower Glide is now reproduced as expected - Playing Legato on Lower when Legato=Off & Seq=Play was stopping Sequencer - Sequencer glide were enabling Glide on Upper Only - Releasing note on Lower could silence note on Upper - Glide can now be enable on the Upper part without disabling Sequencer - Switching Key hold to OFF could silence upper notes OTHER - MIDI loopbacks on swing knob no longer freezes the UI - When saved, Presets were retaining the name of their original slot - 1st note of the sequence is now correctly reproduced after boot - Modulation destinations names are no longer truncated after loading a preset - A4 preset slot is no longer corrupted

New features - Standalone settings mode (Press PRESET + SEQ + MOD) - Preset compare mode (Hold PRESET + Press preset slot) - Custom waveform LFO (Hold LFO < + > to edit the waveform) - LFO triplet and dotted divisions (Hold LFO SEQ-Sync + Press SEQ note, triplet or dotted) - Access 4 pages of custom modulation destinations (16 custom destinations) - Sequencer : Rotate sequence (Hold Tap + press SEQ < or >) - Sequencer : Extend & duplicate sequence (Hold SEQ length + press SEQ >) - Sequencer : Selected step note is now shown on the display - Sequencer : New step edition methods (Hold one step/two steps + turn Mod knob) - Sequencer : Multi-step erase (Hold two steps from the right to the left) - Sequencer : BPM adjustment in whole numbers (Hold tap + turn Rate) - In Duo-Split glide can be applied to the upper part (Hold Voice mode + Press Glide ON/OFF) - Pitch-wheel dead zone can now be edited (MCC / Standalone settings) - Glide mode selection (Rate/Time) Improvements - Bipolar Audio Mod knobs could not be modulated when in their center position. Modulations now apply to the counter-clockwise routing. - Various Panel mode improvements and fixes - Panel button combo shortcuts can now be released in any order - Init preset minor improvements - Local Control state is now maintained on power-up, can be edited with Standalone Settings - Sequencer : Keyboard can now be played when sequencer is ON with an empty sequence - Sequencer : Reworked real-time modulation recording, stops after one cycle - Sequencer : Legato can now be recorded in real time when legato is ON - Sequencer : Reworked editing of notes and Seq Mod across modes (step recording, real-time recording, recording OFF) - Sequencer : Stays in sync when changing preset - Sequencer : Press record now enables the sequencer - Arpeggiator : Velocity value per note - Arpeggiator : Record can no longer be enabled in Arp and Matrix-Arp - Velocity curves improvement [...]

New features - Real Time recording in sequencer for notes and Seq Mod - Matrix Arpeggiator now available - Press Sequencer and Arpeggiator buttons simultaneously - New clock added : 1 pulse per step, 1 pulse (korg) 24ppq & 48ppq - Show offset between preset value and current value by holding PRESET button and turning a knob/slider - Set MIDI note for 0V on both Pitch CV outputs in MIDI Control Center Improvements - Auto Tune improvement : Improvement in Auto Tune feature by holding Panel and pressing Kbd Track in Osc 3 - Faster preset loading - Button parameters are now recalled after reboot in Panel mode - No more clicks when changing presets - Panel+Seq now loads an empty sequence Bugfixes - Autotune does not interrupt sound anymore - VCO3 kbd tracking can now be switched off in Panel mode - Arpeggio not stuck when switching from Duo Split to Paraphonic mode - Arpeggio now properly handles highest notes - Duo Split mode can now be used with local control off - Voice mode now stays in Duo Split when Setting split point - Matrix now shows the right preset after a save - Glide now acts on lower part in Duo Split - Sustain message does not interrupt Note On - No more missed trigs in envelope when using a short gate time and fast tempo in sequencer - Note priority is now stored in the preset - Ties now handled in random sequence mode - No more stuck notes on Midi Out when switching preset - Retrigger sequencer with each note when Legato is set to Off - Error message when managing MatrixBrute presets from MCC with Memory Protect on - No more conflict with LSB messages when 14-bit mode is off

Bugfixes - Key hold is now reset after chaining 2 sequence presets - Sustain handling improvement - CC64 and CC31 can now be automated - MIDI Events lost somewhere on path from MIDI in to USB - Arpeggio in multi-octave mode is properly reset when all notes are released