Arturia DrumBrute firmware

New features - Touch Strip can now send a CC message and can be activated via a CC message - Shift + Swing will Shift all the activated steps of the selected instrument - Pads and Sequencer can now separately send on MIDI DIN and MIDI USB - Switch from Looper to Roller when not in Recording mode : Shift + Step 9 - "Wait to load pattern" shortcut : Shift + Step 14 Improvements - Better handling of Song Position Pointer messages - Better handling of Pads to avoid double trigs Bug fixes - Pattern's tempo is now updated when switching off "Global BPM" - No more freezes when exiting Vegas mode - Changing Bank and Looper are now properly handled in Song mode - Bank A is now initialized after a "Factory Reset" - Unquantized / Shifted notes are now played properly when using external Sync - No more drift in time

New features - Holding a step for more than 0.7 second does not deactivate it anymore, so that the Step Repeat value can be viewed without changing step on/off - Randomness applies only when tracks have active steps within the pattern length - Recording a song now appends patterns and does not erase the existing song anymore - Song Position Pointer now handles the Song length in Song mode. - Exiting Looper keeps position in a song - Use Program Change to switch patterns, and Bank MSB to switch Bank - Use Midi Song Select to switch Songs - Shift + Tempo allows for fine tune of tempo above .99 and below 0 - MIDI Control Change implementation for Local control On/Off for pads, All Notes Off, All Sounds Off - Recording Note On resets Step Repeat value Improvements - MIDI Notes and pad blinking is now longer - Pattern change is prevented while Recording to avoid lost recordings - MIDI loopback removal (Does not echo Midi In anymore) - Clap instrument sound enhancement (Better timing of triggers) - Gobal variables are reset to default value after a hard reset Bug fixes - Various transport enhancements - Restart after pause properly restarts when slaved - Clock Out now in sync when in slave mode - MIDI Start and Continue now properly handled - Bank and Pattern switch always maintains sync - Instruments dimmed on Power On - Metronome sound has no more irregularities - Metronome now starts in sync after a Pause - Looper now stays in sync when slaved to a 2PPQ clock - Set first step of loop in Looper even with shifted steps - Looper handles properly pattern lengths inferior or equal to looper length - AutoSync handles properly changes from master to slave and from slave to master - Pause now properly handled when slaved to 2PPQ clock - Sync works when slaved to a clock with no Run signal - Better handling of 2ppq clock - Empty songs are properly displayed - Tempo now properly limited to 300BPM - Bank Import now works properly [...]