OhmForce Bohm Performer firmware

- Performer FX LED shows now an intermediate state (blinking) while transitioning and waiting for HIT in synced mode - New PERF ON/OFF system setting allows to either toggle FX (TRIG, old behavior, default) or set FX as a gate (GATE) - New LOCK MODEL system setting to prevent accidental model changes in a live set when using STUDIO mode. It is automatically turned off when powering up Bohm - New TAPS OUT system setting to select which envelope to output from Groove (GROOVE, old behavior, default), Inverted Bohm (I BOHM), Performer ducking (PERF) or (non-inverted) Bohm envelope (BOHM) - New IN VOL system setting to lower the volume of the external audio input - New PERF VOL system setting to select which signals are affected by the Performer volume slider/CV, either Bohm and Groove (B+G, old behavior, default) or only Bohm (BOHM) - New PERF MAX system setting to restrict the maximum volume when slider or CV is full on - New DUCK TIME model setting to change the release time of the ducking curve - New DUCK SMTH model setting to smooth the ducking curve - New DUCK BS model setting to set the maximum frequency below which the ducking is operating - New LAYER VOL setting in the XT-88 model, to set the volume of the layering sample - New POST EQ system settings as a sub-menu, with 1 low shelf, 1 peak filter (boost/cut) and 1 high shelf - OLP4 model now supports Groove - When using HIT in sustain mode (using a long gate), Bohm can now reach C1 and C2 for every position of CURVE - It is now possible to load a snapshop with pots positions, which allows to copy a snapshot or make tweaks when preparing a live performance